I ran some Revive turbo cleaner through the intake manifold and it smoothed out a lot of the hesitation but its still drops in to limp mode. Im pretty sure I can cause it to limp. 6th gear, 65-70MPH, approx. 1200-1500 RPM. Maintain that for 10 min or so and it may drop in to limp.3 posts · Joined 2021. #1 · Aug 4, 2021. Hello! I have a big problem. My car is a Ford Mondeo MK4 2.0 TDCI. I changed succesfully engine software in BCM from 46. to 61. and I want relearn PCM form central configuration, but I don' t see this function PCM, IPC, BCM, ABS have DTCs (incompatibility) also instrument cluster shows malfunction
Posted April 20, 2022. Hi, my 2014 Mk2 Galaxy (2.0 TDCI) often goes into limp mode when accelerating hard. It shows " service engine now" on the dash and loses power (I guess the turbo gets disabled?). Stopping the car and switching the engine off will "cure" the problem.I have recently acquired an 2005 Mondeo, 2.0 TDCi 130hp and I have the following problem: When I first start it during the day (doesn't matter if it's cold or warm outside, the problem always happen) I get a good amount of white/blue-ish smoke with a strange smell. Also, the RPM fluctuates for about 30seconds-1 minute. After about 20s-40s starting you can hear the engine getting fuel and struggling to start but eventually starts and runs smoothly after. Without using the park heater the car starts just as fine as you would expect at -24 degrees celcius (=a little slow and with a furious sound) Here is the start after using park heater at about -15.
Budding Enthusiast. 14. Name: Dave. Ford Model: Mondeo 2.0 tdci Titanium x auto estate. Ford Year: 2011. UK/Ireland Location: Essex. Posted August 9, 2018. I recently had a Zafira 1.7 ecoflex cdti and did just over 20,000 miles in a year. It always ran on Shell "V" power (99.9% time) or once or twice BP Ultimate.
Ford Model: mondeo tdci 130 Ford Year: 2006 UK/Ireland Location: Staffordshire Share; Posted July 20, 2010. unbiased Ford car forum / club for owners of Ford
My car is a 2008 140. I needed a new middle section on the exhaust. During that being fitted, it was noticed that there was a split at the flexi. I bought a new downpipe from carparts4less and that was fitted a week later. Almost instantly, I had issues with smoke from under the bonnet. Hi all. I am having problems with my Mondeo 2.0 TDCi 130 when under load over 2000rpm i am loosing boost and leaving grey smoke behind and it sounds like its leaking boost down the exhaust. I have had this problem for a while and so far I have cleaned the turbo out to make sure the vanes wasn't sticking, new map sensor, new maf sensor, new egr .ford mondeo 2.0 tdci forum
